Sealing Head Flat Inlet Poppet 05144662 Waterjet Parts For Sale
1-11024-High-Pressure-Waterjet-Parts-In-Stock-For-Sale-p.html target='_blank'>Sealing Head Flat 3HAC022379-001-Axis-2-3-For-Robot-Water-Jet-Cutting-Machine-Parts-In-Stock-p.html target='_blank'>Sealing-Head-Flat-Inlet-1-11014-Abrasive-Waterjet-Parts-With-Good-Quality-Supplier-p.html target='_blank'>Poppet-05144662-Waterjet-Parts-For-Sale-p.html target='_blank'>Inlet Poppet 05144662 Waterjet Parts For Sale
The Sealing Head Flat Inlet Poppet 05144662 is an OEM stainless‑steel inlet check valve engineered for KMT Streamline Intensifier-Assembly-80072333-Good-Quality-Water-Jet-Parts-In-Stock-p.html target='_blank'>Intensifier sealing head assemblies using a 0.875″ plunger under high‑pressure (60 000 psi / 4 100 bar) service conditions. It serves as the factory‑installed inlet poppet on all 60 K psi‑rated pumps—replacing lower‑pressure variants for cutting above 55 K psi—and drops in directly as a replacement for worn poppets.
Installation & Maintenance
1. Depressurize & Drain: Fully relieve system pressure and drain the Intensifier Pump.
2. Disassemble Sealing Head: Remove the sealing head assembly per KMT service manual instructions.
3. Remove Old Poppet: Use a suitable puller or light press to extract the worn poppet; inspect the bore for wear or debris.
4. Prepare Bore: Clean and lightly polish the seating bore to ensure a smooth surface for the new poppet.
5. Install New Poppet: Press 05144662 into the bore until fully seated; reassemble the sealing head components.
6. Pressure‑Test: Reassemble and repressurize gradually, verifying leak‑free operation at full pressure.
